Breath rear hub 116mm (snail cams included)

Breath rear hub, non disk, 116mm spacing. Body made of 6061-T6 aluminum. Axle made of 7075-T6 aluminum, 12mm diameter (reduced to 10mm at the ends of the axle, in order to fit into the frame).
Features a 106mm spacing, giving the standard 116mm when combined with the 5mm Breath snail cams (supplied with the hub).
Hub shell made from tough, high quality 6061-T6 aluminium.
Anodized red 7075 T6 aluminum axle, now with an oversized 12mm centre to improve strength, but keeping the 10mm ends, suitable for all standard trials frames.
Includes the new Breath snail cams, which are 5mm at the centre (giving the 116mm when used with the Breath hub) and 3mm at the edge to avoid any frame rubbing.
HCH 6001-2RS  sealed bearings keep out all the mud and water, and offer a smooth running.
Standard thread (1,37 "x 24 tpi) suitable for freewheels and fixed sprockets.
It is highly recommended to use the 5mm Breath snail cams, or some spacers will be needed.
Includes 5mm Breath snail cams, M6x25mm steel bolts and ultra light washers.
Available in 32 holes only.

Weight: 153g (+ 17g for bolts and washers + 17g for snail cams)